当前位置: 首页 > 图文教程 > 操作系统 > Unix/Linux > FreeBSD双线负载均衡NAT服务器配置方法

Unix/Linux
在Linux终端下进行BT下载
用软件lm_sensors监测Linux系统和CPU温度
vi编辑器图解教程
Linux系统下光,驱软开关与限速
LINUX系统下MySQL 压力测试工具super smack
Linux系统日志的介绍
LINUX终端下的网络监测工具--Speedometer
解决linux不能上传大于2M文件
Linux常见死机原因
linux系统下邮件服务器sendmail的配置
Linux系统下挂载Windows分区的方法和技巧
解决centos系统 setup时乱码问题
总结一下linux远程控制方法
进图形界面黑屏的解决办法
VMware虚拟机下 Redhat上网
rpm安装以及rpm升级命令
Linux启动出现start ls-disk module sg not found
SecureCRT中文乱码和全屏无法显示菜单的解决办法
完全免费自建Linux防火墙的方法
g++模板编译方法

Unix/Linux 中的 FreeBSD双线负载均衡NAT服务器配置方法


出处:互联网   整理: 软晨网(RuanChen.com)   发布: 2010-01-15   浏览: 105 ::
收藏到网摘: n/a

# vi /etc/rc.conf
================+==============+=================
defaultrouter="221.33.88.254"
ifconfig_fxp0="inet 192.168.0.1 netmask 255.255.255.0"
ifconfig_rl0="inet 221.33.88.2 netmask 255.255.255.0"
ifconfig_rl1="inet 202.0.57.1 netmask 255.255.255.0"
pf_enable="YES"
================+==============+================= # vi /etc/pf.conf
================+==============+=================
##anchors
lan_net = "192.168.0.0/24"
int_if  = "fxp0"
ext_if1 = "rl0"
ext_if2 = "rl1"
ext_gw1 = "221.33.88.254"
ext_gw2 = "61.0.57.254" ##nat outgoing connections on each internet interface
nat on $ext_if1 from $lan_net to any -> ($ext_if1)
nat on $ext_if2 from $lan_net to any -> ($ext_if2) ##default deny
block in  from any to any
block out from any to any ##pass all outgoing packets on internal interface
pass out on $int_if from any to $lan_net
##pass in quick any packets destined for the gateway itself
pass in quick on $int_if from $lan_net to $int_if
##load balance outgoing tcp traffic from internal network.
pass in on $int_if route-to \
{ ($ext_if1 $ext_gw1), ($ext_if2 $ext_gw2) } round-robin \
proto tcp from $lan_net to any flags S/SA modulate state
##load balance outgoing udp and icmp traffic from internal network
pass in on $int_if route-to \
{ ($ext_if1 $ext_gw1), ($ext_if2 $ext_gw2) } round-robin \
proto { udp, icmp } from $lan_net to any keep state ##general "pass out" rules for external interfaces
pass out on $ext_if1 proto tcp from any to any flags S/SA modulate state
pass out on $ext_if1 proto { udp, icmp } from any to any keep state
pass out on $ext_if2 proto tcp from any to any flags S/SA modulate state
pass out on $ext_if2 proto { udp, icmp } from any to any keep state ##route packets from any IPs on $ext_if1 to $ext_gw1 and the same for
##$ext_if2 and $ext_gw2
pass out on $ext_if1 route-to ($ext_if2 $ext_gw2) from $ext_if2 to any
pass out on $ext_if2 route-to ($ext_if1 $ext_gw1) from $ext_if1 to any
================+==============+================= # vi /etc/sysctl.conf
net.inet.ip.forwarding=1