当前位置: 首页 > 图文教程 > 操作系统 > Unix/Linux > FreeBSD双线负载均衡NAT服务器配置方法

Unix/Linux
Linux中NE2000兼容网卡的安装
sis650显卡驱动自定义安装终极指南(RH80)
配置好显卡驱动Linux下玩游戏同样爽
linux设备驱动笔记:字符设备驱动
把设备驱动程序编译进嵌入式Linux内核
删除Linux引导界面的方法及注意事项
在Linux操作系统下如何开启硬盘DMA
从Linux BIOS的起源 看未来主板框架
深入浅出 Linux字符设备驱动程序解析
Linux系统启动引导程序配置文件解析
深入浅出 Linux设备驱动异步通知介绍
深入浅出 Linux设备驱动中断处理介绍
新手看招 Linux操作系统的目录结构一览
菜鸟乐园 Linux中常见文件系统格式介绍
Motorola微处理器bootloader分析与应用
实用技巧 Linux系统的经典使用技巧八则
Linux操作系统下IPTables配置方法详解
Linux系统中增加Swap分区文件步骤方法
使用Openssh工具远程管理Solaris 10
uClinux中添加用户应用程序的详细方法

Unix/Linux 中的 FreeBSD双线负载均衡NAT服务器配置方法


出处:互联网   整理: 软晨网(RuanChen.com)   发布: 2010-01-15   浏览: 187 ::
收藏到网摘: n/a

# vi /etc/rc.conf
================+==============+=================
defaultrouter="221.33.88.254"
ifconfig_fxp0="inet 192.168.0.1 netmask 255.255.255.0"
ifconfig_rl0="inet 221.33.88.2 netmask 255.255.255.0"
ifconfig_rl1="inet 202.0.57.1 netmask 255.255.255.0"
pf_enable="YES"
================+==============+================= # vi /etc/pf.conf
================+==============+=================
##anchors
lan_net = "192.168.0.0/24"
int_if  = "fxp0"
ext_if1 = "rl0"
ext_if2 = "rl1"
ext_gw1 = "221.33.88.254"
ext_gw2 = "61.0.57.254" ##nat outgoing connections on each internet interface
nat on $ext_if1 from $lan_net to any -> ($ext_if1)
nat on $ext_if2 from $lan_net to any -> ($ext_if2) ##default deny
block in  from any to any
block out from any to any ##pass all outgoing packets on internal interface
pass out on $int_if from any to $lan_net
##pass in quick any packets destined for the gateway itself
pass in quick on $int_if from $lan_net to $int_if
##load balance outgoing tcp traffic from internal network.
pass in on $int_if route-to \
{ ($ext_if1 $ext_gw1), ($ext_if2 $ext_gw2) } round-robin \
proto tcp from $lan_net to any flags S/SA modulate state
##load balance outgoing udp and icmp traffic from internal network
pass in on $int_if route-to \
{ ($ext_if1 $ext_gw1), ($ext_if2 $ext_gw2) } round-robin \
proto { udp, icmp } from $lan_net to any keep state ##general "pass out" rules for external interfaces
pass out on $ext_if1 proto tcp from any to any flags S/SA modulate state
pass out on $ext_if1 proto { udp, icmp } from any to any keep state
pass out on $ext_if2 proto tcp from any to any flags S/SA modulate state
pass out on $ext_if2 proto { udp, icmp } from any to any keep state ##route packets from any IPs on $ext_if1 to $ext_gw1 and the same for
##$ext_if2 and $ext_gw2
pass out on $ext_if1 route-to ($ext_if2 $ext_gw2) from $ext_if2 to any
pass out on $ext_if2 route-to ($ext_if1 $ext_gw1) from $ext_if1 to any
================+==============+================= # vi /etc/sysctl.conf
net.inet.ip.forwarding=1